AutoCAD External References would be resolved
from the wrong location if a copy of the original vault was used, while
the original vault was still available on the network. This is now fixed.
Custom properties were not created in a SolidWorks
document when saving a new document from SolidWorks with the Application
Integration. This is now fixed.
When the title block in an Inventor drawing contains
Prompted Entries, these entries would be reset to the default values after
the AutoManager Add-in updated the other properties in the title block.
This is now fixed.
After creating a copy of an Inventor assembly,
and either manually or programmatically redirecting all references to
the new copies of the files, Inventor would still use the original documents.
This is now fixed.
When the AutoManager Add-in was loaded in Inventor
it was impossible to edit parts that were not in the AutoManager vault.
This is now fixed.
When releasing an Inventor drawing, or bringing
it to a different state in single document workflow, it is possible to
update the document's properties. This update normally uses the Inventor
Apprentice (part of Inventor Design Tracking) to do this update, but has
the side-effect that the graphical representation of the title block is
not refreshed. It is now also possible to use Inventor itself to do the
update, which will also redraw the graphical information. To do this,
a full installation of Inventor must be available on the workstation,
and an additional DWORD value must be set in the registry key HKEY_LOCAL_MACHINE\SOFTWARE\Cyco\AutoManager
Meridian 2003\CurrentVersion\InventorLink:
"RedrawTitleBlocksOnUpdate"=dword:00000001
Note that using Inventor instead of the Apprentice may slow down the
update significantly.